00 SERIES ADJUSTABLE BASE info@lucidmattress.com 888-975-8243 OWNER’S MANUAL 100 SERIES ADJUSTABLE BASE SERIAL NO.
100 SERIES ADJUSTABLE BASE CONTENTS Safety & Warranty Warnings 04 Overview & Parts List 06 Assembly 08 Remote Control 12 Synchronizing Two Bases 14 Troubleshooting 16 Warranty 18
Safety & Warranty Warnings IMPORTANT: PLEASE READ ALL INFORMATION CAREFULLY BEFORE USING THIS PRODUCT. SAVE THESE INSTRUCTIONS. WEIGHT LIMITS • This product is not rated to support weights in excess of: 650 lbs (295 kgs) WARRANTY WARNINGS SAFE OPERATION Do not open or tamper with control box, motors, or remote. The warranty will be void if the internal workings of these components are tampered with. • Use caution when having liquids in or around the bed to ensure no spilling occurs.
Overview & Parts List GET TO KNOW YOUR ADJUSTABLE BASE WIRED REMOTE RETAINER BAR Before beginning assembly of your 100 Series Adjustable Base, please take a moment to familiarize yourself with the parts and location of components, as explained here. If any parts or components are missing, or are different than shown in the adjacent image, do not attempt to complete the assembly process and contact customer support by calling 888-975-8243 or emailing info@lucidmattress.
Assembly NOTES STEP 3 1. 2. Two people are required to assemble this adjustable base. Open the carton in the flat position, bottom facing up, to avoid damage. To install the six (6) legs, thread the bolt of the leg into the frame and tighten by hand. STEP 1 Remove folded bed base from the box and carefully unfold the base. Set it on its side with the base half-way open.
Assembly, ctd. STEP 6 With two (2) to four (4) people, lift the bed by the outer frame and turn it over so the mattress side is facing up. Take caution not to lift the bed by any moving parts, the retainer bar, or to use the legs as pivot points causing angled pressure as this may cause damage. Avoid dragging the base across the floor. STEP 7 To install the mattress retainer bar, insert ends into holes at the foot of bed.
Remote Control OVERVIEW All of the functions of the bed, explained here, can be operated with the remote control. Ensure that the remote is plugged into the receiving cord located at the bottom of the base.
Synchronizing Two Bases For Twin XL bases only OVERVIEW Two Twin XL bases may be placed next to each other to form a King. Both sides can be operated independently with their own remotes or, if desired, a single remote can be used with both bases. Using a single remote for both bases will result in the bases moving jointly. TO SYNC REMOTE TO TWO BASES: STEP 1 Ensure both bases (A & B) are plugged into a power source and both in the flat position.
Troubleshooting PROBLEM POSSIBLE SOLUTION No features of the base will activate. Ensure that all wired connections are secured bellow the bed base. Unplug the power cord, wait 30 seconds and plug back in to reset electric components. The surge protection or the electrical outlet may be defective. Test the outlet by plugging in another working appliance. Head or foot section will elevate, but will not return to the flat position. Bed mechanism may be obstructed. Elevate bed and check for obstruction.
Warranty Information Notes 5 YEAR LIMITED WARRANTY WHAT IS COVERED This warranty covers any defects in materials or workmanship under the conditions and exceptions stated below and applies only to the original purchaser. The warranty is void if purchased or transported outside the USA. This warranty excludes commercial use. HOW LONG COVERAGE LASTS This warranty runs for up to five (5) years from the date of purchase, according to the tiers set forth below.
