User's Manual
6 7
RECHARGING
Remove LucereLights from silicone bases for charging. The charging cords can make them
fall from the silicone mounts. The mounts only support the lamps themselves.
The charger supplied is for 110-240 volt input. Recharging takes between 1 and 2 hours.
When the switch is in ON position the lithium ion battery will stay charged for 1 month.
When switch is in OFF position the battery will stay charged for 6 months.
SAFETY
CAUTION: The light is not tolerant of immersion in water. Do not drop in a bathtub
or toilet! Do not hold under running water. Do not use in a shower. Do not allow to be
exposed to rain or snow.
Do not drop on hard surfaces.
Do not use USB cable if frayed or torn.
LucereLight is safe for air travel. Its lithium battery meets all Aviation Guidelines.
When traveling by air, turn the power saver switch to the OFF position.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS:
1. Never use the Lucere Light if the lamp housing is damaged, broken or missing.
2. Heed all warnings.
3. Do not look directly at lighted lamp.
4. If the lamp, power supply cord or cord has been damaged in any way,
liquid has spilled or objects have fallen into the lamp, the lamp has been
exposed to rain or moisture, does not operate normally or has been
dropped or damaged, it should not be operated.
5. Read this user manual carefully before you use the Lucere Light and save it
for future reference.
6. Water and electricity are a dangerous combination. Be careful not to let the
Lucere Light get wet, whether charging or not.
7. Make sure the adapter does not get wet.
8. Do not immerse in water or rinse under the tap.
9. Only use the original adapter. If the adapter is damaged, do not use.
10. This appliance is for indoor use only.
11. Protect the power cord from being walked on or pinched, particularly at plugs,
outlet and point where they exit from lamp.
* SAVE THESE INSTRUCTIONS *
FCC REGULATORY STATEMENTS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the Federal Communication Commission (FCC) rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment causes harmful interference to radio or
television reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by doing one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS
NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODI-
FICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
RF EXPOSURE WARNING
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 20 cm during normal
operation and must not be co-located or operating in conjunction with any other antenna or
transmitter.