User manual

Chapter 6 Cajun Campus CLI – Layer 2
Cajun P332MF User’s Guide 67
Set Commands Summary Table
Following is a Table of the Privileged Level set commands.
• set logout Set the number of minutes before an
inactive CLI session automatically logs
out
Page 69
• set timezone Set the timezone for the system Page 70
• set ntp server Set the NTP server address Page 70
• set ip route Add IP addresses to the IP routing table Page 70
• set snmp trap Set the SNMP trap of the system or add/
delete an entry into/from the SNMP
trap receiver table
Page 71
• set snmp trap auth Enable/Disable the SNMP
authentication trap
Page 72
• set snmp retries Set the number of SNMP retries Page 72
• set snmp timeout Set the SNMP timeout Page 73
• set system
location
Set the system location Page 73
• set system name Set the system name Page 73
• set system contact Set the system contact person Page 73
• set interface Configure the management interface of
the device
Page 74
• set port level Set the priority level of a port Page 74
• set port
negotiation
Set the autonegotiation mode of a port Page 75
• set port enable Administratively enable a port Page 75
• set port disable Administratively disable a port Page 75
• set port speed Set the speed for a 10/100 port Page 76
• set port duplex Set the duplex mode of a port Page 76
• set port name Assign a name to a port Page 76
• set port trap Enable/Disable the SNMP up/down link
traps sent for port
Page 77