User manual

ManualsBrandsLucent Technologies ManualsOtherServer lucent

861

862

863

864

865

866

867

868

869

870

DEFINITY Enterprise Communications Server Release 6

Maintenance for R6vs/si

555-230-127

Issue 1

August 1997

Maintenance Object Repair Procedures

Page 10-204BRI-SET, ASAI-ADJ, BRI-DAT

BRI Set Audits Test (#630)

This is a series of two tests which are classified as audits. The switch sends

messages to the BRI endpoint to perform the following tests:

■ Ringer Audit - This audit ensures that both the switch and the endpoint

agree as to the current state of the endpoint’s ringer.

■ Lamps Audit - This audit ensures that both the switch and the endpoint

agree as to the current state of the endpoint’s lamps.

■ Call Activity Audit - This audit ensures that the state of calls is consistent

between the switch and the endpoint.

2068 ABORT The endpoint has rejected the switch sent application

message. This indicates that the endpoint does not support

the ISDN-BRI Management and Maintenance Procedure for

Endpoint Service Messages.

1. Use the change station extension command and change

the MIMs Supported? field to "no."

2069 ABORT The endpoint has returned an error response to the switch sent

application message.

1. Retry the command at one-minute intervals a maximum of

five times.

2. If the test continues to abort, escalate the problem.

2000 FAIL No response is received from the endpoint or the adjunct. For

BRI endpoints:

1. Consult the endpoint documentation to determine if

ISDN-BRI Management and Maintenance Procedures are

supported. If not supported, use the change station

extension command to change the "MIMs Supported?"

field to "no." Use the busyout station extension and

release station extension commands to busyout and

release the endpoint to resolve any endpoint alarms

resulting from failure of this test.

2. If the endpoint supports these procedures and the test

continues to fail, assume the endpoint is defective and

replace it.

PASS The endpoint has successfully responded to the switch’s

application message.

Table 10-72. TEST #629 BRI Layer 3 Query — Continued

Error

Code

Test

Result Description/ Recommendation

Continued on next page