User manual

DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-73ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon Analog Line)
10
Table 10-29. TEST #36 Station Status and Translation Audits and Updates Test
Error
Code
Test
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1004 ABORT System resources required to run this test are not available. The port may
be busy with a valid call. Use the display port PCSSpp command to
determine the station extension. Use the status station command to
determine the service state of the port. If the service state indicates that the
port is in use, then the port is unavailable for certain tests. (Refer to the
"Status Commands" section in Chapter 8, "Maintenance Commands and
Trouble-Clearing Aids", for a full description of all possible states.) You
must wait until the port is idle before retesting.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort and the port is not in use, escalate the
problem.
1005 ABORT The test was aborted due to a configuration problem. This code will result
under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13,14 and 15
— TN769 vintages 3,4 and 5
1006 ABORT This port has been busied out by command or taken out-of-service by the
failure of the NPE Crosstalk Test.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If
this error is present, then release the port with the release station
extension command and run the test again.
2. Look in the Error Log for Error Type 1025 (NPE Crosstalk Test failed)
for this port. If this error is present, then investigate the errors
associated with the NPE Crosstalk Test (#6) first.
3. Make sure that the terminal is connected and in service, and then
retest.
ABORT Could not allocate the necessary system resources to run this test.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
Continued on next page