User manual

DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-308status system
8
busyout/entering SPE busied out and in the process of restarting the switch
software on this SPE. After the switch software finishes its
initialization, the standby SPE is available for maintenance
functions on the standby SPE.
busyout/testing SPE busied out, however, the switch software on this SPE has
been restarted and is currently in the process of executing a
test command.
busyout/
not-refreshed
SPE busied out, however, the busyout spe-standby
command was executed at a time when the standby memory
was not refreshed. The standby SPE is not able to perform any
maintenance or SAT-requested activities until a successful
refresh spe-standby command is executed.
busyout/
list-config
SPE busied out, however, the switch software on this SPE has
been restarted and is currently executing a list configuration
command.
busyout/status SPE busied out, however, the switch software on this SPE has
been restarted and is currently in the process of executing a
status card-mem command.
Maintenance Modes
1
maint/init SPE in maintenance mode (system restarted within the last 10
minutes). During this time, the standby SPE is not placed into
standby mode just in case a core dump is being written to the
tape or memory card on the standby SPE.
maint/idle SPE in maintenance mode, but no current maintenance
activity. The active SPE can be either active or selected.
maint/entering SPE currently restarting the switch software on this SPE. After
the switch software on this SPE finishes its initialization, the
standby SPE is available to perform maintenance functions.
maint/testing SPE in maintenance mode executing a test command.
maint/
not-refreshed
SPE in maintenance mode executing a destructive
background maintenance test that has temporarily left the
standby memory not refreshed. After the current test finishes,
background maintenance refreshes the standby SPE.
maint/not-tested SPE in maintenance mode because previously the active SPE
had been selected with the SPE select switches. Since the
active SPE was not selected, the standby has not been tested
to ensure the standby can enter standby mode. Once the
standby is tested successfully, the standby returns to standby
mode.
maint/list-config SPE in maintenance mode and currently executing a list
configuration command.
maint/save~trans SPE in maintenance mode and is currently executing a save
translation command.