User manual

DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Error Messages
Page A-23disable administered-connection
A
If there is no update file on active processor, the following message is displayed:
No update file on tape
If the standby SPE is NOT in standby mode, the following message is displayed: is
displayed:
Cannot access the standby SPE at this time
If the active SPE cannot establish a communication path to the standby SPE, the
following message is displayed:
Could not establish netcon data call between SPE’s
If the command entered is in conflict with another currently executing command, then a
message will be displayed showing the login id of the conflicting user and the conflicting
command. The message is as follows:
’login id’:’command’ has a command conflict
If the update file is too large to fit on device, the following message is displayed:
Update file is too large to fit on device
If the checksum of the files is not correct, the following message is displayed:
Update file checksum failed
If the update is successful the following message is displayed:
Command completed successfully
disable administered-connection
Help Messages
If the user presses HELP after entering "disable administered-connection," the following
message will be displayed:
Enter assigned administered connection number(1-128) or ’all’
Error Messages
If the administered connection number entered is not "all" and is non numeric, the
following message is displayed:
Identifier invalid
If the administered connection number entered is not within the valid range of
connections, the following message is displayed:
Entry out of range
If the connection number entered is not administered, the following message is
displayed: