User manual

DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-1179STBY-SPE (Standby SPE)
10
2025
(cont’d.)
ABORT 6. Issue the display errors command and check to see if an Error Type 80 is
logged against STBY-SPE. If so, the problem is the carrier A Duplication
Interface circuit pack. Replace the carrier A Duplication Interface circuit
pack as described in Chapter 6, ‘‘
Reliability Systems: A Maintenance Aid’’
and proceed with Steps 10, 11, and 12.
7. Issue the display errors command and check to see if an Error Type 82 is
logged against STBY-SPE. If so, the problem is the carrier B Duplication
Interface circuit pack. Replace the carrier B Duplication Interface circuit
pack as described in Chapter 6, ‘‘
Reliability Systems: A Maintenance Aid’’
and proceed with Steps 10, 11, and 12.
8. Issue the display errors command and check to see if Error Type 85 is
logged against STBY-SPE. If so, the problem may be the Standby SPE
Memory circuit pack. Replace the Memory circuit pack as described in
Chapter 6, ‘‘
Reliability Systems: A Maintenance Aid’’ and proceed with
Steps 10, 11, and 12.
9. Issue the display errors command and check to see if Error Type 58 is
logged against STBY-SPE. If Error Type 58 is logged OR if no error type is
logged, the problem is either the Standby SPE Processor circuit pack, the
Standby SPE Memory circuit pack, or the carrier A Duplication Interface
circuit pack.
■ If the red LED on the Standby SPE Processor circuit pack is on and the
Standby SPE Processor circuit pack has not been replaced yet,
replace the Standby SPE Processor circuit pack as described in
Chapter 6, ‘‘
Reliability Systems: A Maintenance Aid’’ and proceed with
Steps 11, 12, and 13. If the red LED on the Standby SPE Processor
circuit pack is on, and if the Standby SPE Processor circuit pack has
been replaced, replace the Standby SPE Memory circuit pack as
described in Chapter 6, ‘‘
Reliability Systems: A Maintenance Aid’’ and
proceed with Steps 11, 12, and 13.
Table 10-410. Test Result Error Codes Associated with the Standby SPE — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page