User manual

DEFINITY Enterprise Communications Server Release 6

Maintenance for R6vs/si

555-230-127

Issue 1

August 1997

Routine Maintenance Procedures

Page 5-60System Features

by call) service type, then the Testcall Service field on Trunk Group

Administration Form must have been administered also.

To initiate an outgoing ISDN-PRI test call in the asynchronous method, issue the

following command:

test isdn-testcall <grp>/<mbr> [minutes]

This command enables you to specify a specific the trunk on which to originate

the ISDN-PRI test call.

NOTE:

The optional qualifier can also be used that specifies in minutes the

duration of the test call. If no duration is specified, the default duration is

used which is 8.4 or 9.6 seconds. The qualifier "minutes" accepts the

numeric values one through 120 (that is, two hours = 120 minutes).

Screen 5-6

shows a typical response to the test isdn-testcall command:

Screen 5-6. Typical Response to Test ISDN-Testcall Command

The meaning of the information displayed in response to the above command is

described in the following list.

■ Port: The port address (PCSSpp) is the port network number, carrier

designation, slot, and circuit of the maintenance object under test.

■ Maintenance Name: The type of maintenance object tested.

■ Test Number: The actual test that was run.

■ Test Results: Indicates whether the test passes, fails, or aborts.

■ Error Code: Additional information about the results of the test. (See the

ISDN Trunk Maintenance documentation for details.)

The functions of the clear, list, and status commands associated with the ISDN

Testcall are summarized in the following list. For more detailed information, refer

to the appropriate sections as directed.

test isdn-testcall

Port Maintenance Name Test Number Test Result Error Code

1B1501 ISDN-TRK 258 PASS