User manual

DEFINITY Enterprise Communications Server Release 6

Maintenance for R6vs/si

555-230-127

Issue 1

August 1997

Maintenance Object Repair Procedures

Page 10-803MET-LINE (MET Line)

MET-LINE (MET Line)

Electronic Station is the user-friendly term to denote the MET (Multibutton

Electronic Telephone) Station Set. The MET sets were originally introduced for

use in earlier PBX systems but can now be used in Generic 1 switches.

The TN735 MET Line circuit pack supports four of these Multifunctional

Electronic Sets. Each MET set uses three pairs of wires: an analog voice pair, a

transmit pair, and a receive pair. Power is sent over the transmit and receive

pairs. The MET Line circuit pack supports all 10-, 20-, and 30-button sets.

MET Line interactions are shown in Figure 10-65

1. Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier

designation (for example, A, B, C, D, or E); SS is the address of the slot in the carrier

where the circuit pack is located (for example, 01, 02, ..., etc.); and pp is the 2-digit port

number (for example, 01).

MO Name (in

Alarm Log)

Alarm

Level Initial Command to Run

Full Name of MO

MET-LINE MINOR test port PCSSpp l MET Line

MET-LINE WARNING test port PCSSpp sh MET Line