User manual

DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127
Issue 1
August 1997
Maintenance Object Repair Procedures
Page 10-590ERR-LOG (Error Log)
10
ERR-LOG (Error Log)
Functional Description
The ERR-LOG MO is responsible for the sanity of the Alarm Log, the Hardware
Error Log, and the Software Error Log. If an inconsistency is detected in any one
of these logs, all logs are re-initialized and a hardware error is logged against
ERR-LOG indicating the time of inconsistency. There are no tests and no alarms
for the Error Log MO. This MO exists solely for the purpose of allowing errors to
be logged against it.
Hardware Error Log Entries and Test to Clear
Values
Notes:
a. This error indicates that an inconsistency was detected in either the Alarm
Log, the Hardware Error Log, or the Software Error Log. To recover from
this error, all of the logs were cleared and re-initialized. Any alarms that
were active at the time of this error have been cleared. There is no
associated test for this error. If the error persists, escalate the problem.
The Aux data value indicates when the inconsistency was found:
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to
the appropriate test description and follow the recommended procedures.
MO Name (in
Alarm Log) Alarm Level
Initial Command to
Run Full Name of MO
ERR-LOG none none Error Log
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
Any Any Any Any none
510 (a) Any none none none none
0 Found during a periodic audit of the Error Log
1 Found after an extended reboot
2 Found after a reboot
3 Found after a Reset System 3 (Cold_1)