User manual

ManualsBrandsLucent Technologies ManualsOtherServer lucent

1031

DEFINITY Enterprise Communications Server Release 6

Maintenance for R6vs/si

555-230-127

Issue 1

August 1997

Maintenance Object Repair Procedures

Page 10-374DATA-CHL (Network Control Data Channel)

1000 ABORT For this test, an Error Code of 1000 can have one of several different

meanings:

a. The target DATA-CHL is busy and, therefore, not available for use.

b. System resources required to run this test are not available.

c. Internal system error

Determine if the target DATA-CHL is in use for some other function (that is,

CDR Link, System Printer Link, Journal Printer Link, PMS Link, or secondary

administration terminal connection) as described previously in the "Status

of network Control Data Channels" section. If so, check for errors on the

function that is using the DATA-CHL. If there are no errors, there is a high

probability that the DATA-CHL is not defective.

Proceed with the remaining steps only if it is necessary to completely

test the target DATA-CHL:

1. If the target DATA-CHL is in use for some other function, busyout the

function (PRI-CDR/SEC-CDR, SYS-PRNT, PMS-PRNT/JNL-PRNT,

PMS-LINK) or the DATA-CHL (secondary administration terminal

connection only).

2. Retry the command at 1-minute intervals a maximum of 5 times.

3. Restore any busied out PRI-CDR/SEC-CDR, SYS-PRNT,

PMS-PRNT/JNL-PRNT, PMS-LINK MOs to service before moving on to

another activity.

1006 ABORT For this test, an Error Code of 1006 can have one of several different

meanings:

a. System resources required to run this test are not available.

b. Internal system error. Retry the command at 1-minute intervals a

maximum of 5 times.

1016 ABORT Resources for the test are not available.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1018 ABORT Test disabled via software patch.

2000 ABORT Internal system error

2003 ABORT Internal system error

1. Retry the command at 1-minute intervals a maximum of 5 times.

Table 10-119. TEST #111 Data Channel Local Loop Back Test — Continued

Error

Code

Test

Result Description/Recommendation

Continued on next page