User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-49ANL-16-L (16-Port Neon Analog Line)
10
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present or some Tone
Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to "TTR-LEV
(TTR Level)" Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer to "TTR-LEV
(TTR Level)" Maintenance documentation.
3. If neither condition exists, retry the test at one-minute intervals a
maximum of five times.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted. Use the display port PCSSpp command to determine the station
extension. Use the status station command to determine the service state
of the port. If the service state indicates that the port is in use, the port is
unavailable for certain tests. (Refer to the "Status Commands" section in
Chapter 8, "Maintenance Commands and Trouble-Clearing Aids", for a full
description of all possible states.) You must wait until the port is idle before
retesting.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort and the port is not in use, escalate the
problem.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a
voice terminal (for example, the modem pool member or music on hold).
1018 ABORT The test has been disabled via administration. The default for the ’Test’
field on the ’Station’ form is ’y’; thus, you may want to determine why this
field has been set to ’n’ on this station (this may be due to the ringing
application test 48, which can be customer or terminal disturbing).
1. To enable the test for a particular station being tested, enter change
station extension and set the ‘Test?’ field on the station from 'n' to 'y.'
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available. This could be
due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Table 10-20. TEST #6 NPE Crosstalk Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page