User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-517status system
8
SERVICE STATE The operational state of the TDM Bus circuit pack. The possible
states are as follows:
— in
The TDM Bus is installed in the system and is in-service.
— out
The TDM Bus has failed certain maintenance tests and has
been removed from service.
CONTROL
CHANNEL
Indicates whether the control channel is on this TDM Bus. Either
y(es) or n(o) is displayed.
DEDICATED
TONES
Indicates whether the dedicated tones are on this TDM Bus. Either
y(es), n(o) is displayed.
PKT The Packet Bus identifier, which is the same as the cabinet number.
Valid Packet Buses are 1, 2 and 3. If the system is running on a
X75XE cabinet all the PKT fields will be blank and the following will
be displayed instead:
S75XE does not support Packet
Refer to Packet Bus Maintenance descriptions for more information.
SERVICE STATE The operational state of the Packet Buses. Possible states are:
— in
The Packet Bus is in-service and operating normally.
—out
The Packet Bus has failed certain maintenance tests and has
been removed from service.
— reconfig
The Maintenance/Test circuit pack has swapped one or more
signal leads because of lead faults detected during testing
(High or Critical Reliability System only).
— open lds
The Maintenance/Test circuit pack can not correct all of the
Packet Bus faults. There are open leads, but the Packet Bus is
still at least partly functional (on a High or Critical Reliability
System only).
— unavail
If the system has an EPN that is currently down, then unavail is
displayed for the Packet Bus.
— <blank>
If the system does not have the Packet Bus feature, a blank is
displayed.