User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-370set vector
8
Vector-Condition Mapping
value WARM COLDII COLDI REBOOT
0n n n n
1y n n n
2n y n n
3y y n n
4n n y n
5y n y n
6n y y n
7y y y n
8n n n y
9y n n y
an y n y
by y n y
cn n y y
dy n y y
en y y y
fy y y y
spe-standby This option is only specified for a High or Critical Reliability System and
is the default option. It specifies that if a restart occurs on the active
SPE and the corresponding vector bit is set, a core dump will be taken
on the standby SPE after the standby SPE has performed a refresh of
memory.
spe-active This option is only specified for a High or Critical Reliability System. It
specifies that if a restart occurs on the active SPE and the
corresponding vector bit is set, a core dump will be taken on the active
SPE. This option is the default in simplex SPE systems (no options are
specified in a simplex SPE system, but spe-active is always assumed).
This option is service disrupting.
spe-maint This option is only specified for a High or Critical Reliability System. It
specifies that if a restart occurs on the active SPE and the
corresponding vector bit is set, a core dump will be taken on the
standby SPE without the standby SPE performing a refresh of memory.