User Guide

ManualsBrandsLucent Technologies ManualsOtherR5SI

2581

DEFINITY Enterprise Communications Server Release 5

Maintenance and Test for R5vs/si

555-230-123

Issue 1

April 1997

Maintenance Object Repair Procedures

Page 10-1647VC-DSPPT

Table 10-482. TEST #1105 VC-DSP Port DSP Loopback Test

Error

Code

Test

Result Description/Recommendation

1000 ABORT System resources required to run this test are not available, or the port is

busy with a valid call.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1002 ABORT The system could not allocate time slots for the test, the traffic load on the

system is very high, or time slots are out-of-service due to TDM-BUS errors.

Refer to “TDM-BUS” to diagnose TDM Bus errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic,

repeat the test at 1-minute intervals a maximum of 5 times.

1003 ABORT The system could not allocate a Tone Detector for the test, the system is

oversized for the number of Tone Detectors present, or some Tone

Detectors are out-of-service.

1. Resolve any “TTR-LEV” errors.

2. Resolve any “TONE-PT” errors.

3. If neither condition exists, retry the test at 1-minute intervals a maximum

of 5 times.

1004 ABORT The port has been seized by a user for a valid call. Use the status station

command for the station associated with this port and determine if the port

is available for testing

1. Retry the command at 1-minute intervals a maximum of 5 times.

2000 ABORT Response to the test request was not received from the VC-BD circuit pack

within the allowable time period.

1. If this result occurs repeatedly, reset the circuit pack if the other ports

are not in use by using the busyout port PCSSpp and reset port

PCSSpp commands.

2. If this result occurs again, replace the circuit pack.

2012 ABORT Internal system error

1. Retry the command at 1-minute intervals a maximum of 5 times.

2100 ABORT Could not allocate the necessary system resources to run this test.

1. Rerun the test at 1-minute intervals a maximum of 5 times.

0, 1 FAIL The VC-DSPPT DSP Loopback Test failed.

1. Replace the circuit pack.

PASS The VC DSPPT DSP Loopback Test passed

Continued on next page