User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1444TIE-DS1 (DS1 Tie Trunk)
10
1020 ABORT The test did not run due to an already existing error on
the specific port or due to a more general circuit pack
error.
1. Examine the error log for existing errors against this
port or the circuit pack and attempt to diagnose the
already existing error.
2. Retry the test.
3. If the test continues to abort, escalate the problem.
1040 ABORT This test is not performed for trunk ports administered as
access endpoints.
1. Verify this port is an access endpoint by using the
display port command.
2. If the port has been administered as an access
endpoint, this test should abort.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to
run this test.
1. Retry the command at one-minute intervals for a
maximum of five times.
2. If the test continues to abort, escalate the problem.
2053 ABORT/
FAIL
(1)
At least one of the following errors is found on the circuit
pack: 1281: Loss of Signal, 1793: Blue Alarm, 2049: Red
Alarm, 2305: Yellow Alarm, 1537: Hyperactivity.
1. Look for the above error types in the Hardware Error
Log and follow the procedures given in the DS1-BD
tests for the listed error types.
Table 10-440. TEST #136 DS1 Tie Trunk Seizure Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page