User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1365TAPE (Tape Unit) [G3iV1.1-286]
10
9026 Hardware error detected. 1. Do the steps below following the
directions in the ‘‘
Tape Maintenance
and Repair Procedures’’ section.
2. Issue the test tape long
commnd.dispatch with tape unit.
3. If the test fails, make sure tape is fully
inserted.
4. If the test continues to fail, clean the
tape head.
Use original tape and
retest.
5. If the test still fails, swap tape unit,
use
original tape
and retest.
NOTE:
It is very important that hardware
problems are resolved
before using
backup tape.
6. If fails again, swap tape and restest.
7. If the problem still exists, escalate the
problem.
9027 The test failed because the
software could not access
the tape hardware.
9030 Internal system error. 1. Follow the steps provided in the ‘‘
Tape
Maintenance and Repair Procedures’’
section.
2. If problem still exists then escalate.
9032 Inability to read a
significant portion of the
scratch area on the tape.
1. Follow the steps provided in the ‘‘
Tape
Maintenance and Repair Procedures’’
section.
2. If problem still exists then escalate.
Table 10-415. Table A: Tape Unit Aux Data Table — Continued
Aux Data/
Error Codes Explanation Strategy
Continued on next page