User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1241SHDW-LNK (Memory Shadowing Link)
10
2047 FAIL The Standby SPE Maintenance/Tape Processor released the Standby SPE
processor with a request to clear Standby SPE Memory; Standby SPE
Memory was not successfully cleared.
1. Check for Standby SPE Processor errors and alarms. Refer to PROCR
(80286 Processor Circuit Pack) Maintenance documentation and follow
the prescribed procedures.
2. Check for Standby SPE Memory errors and alarms. Refer to MEM-BD
(Memory) Maintenance documentation and follow the prescribed
procedures.
3. If all problems found in Steps 1 and 2 have now been repaired,
proceed with Step 5. If no problems were found in Steps 1 and 2,
proceed with Step 4.
4. Issue the display errors command and check to see if an Error Type
58 is logged against STBY-SPE. If an Error Type 58 is logged OR if no
error types are logged against STBY-SPE, the problem is either the
Standby SPE Processor circuit pack or the Standby SPE Memory circuit
pack.
■ If the red LED on the Standby SPE Processor circuit pack is on and
the Standby SPE Processor circuit pack has not been replaced yet,
replace the Standby SPE Processor circuit pack as described in
Chapter 6, ‘‘
Reliability Systems: A Maintenance Aid’’ and proceed
with Steps 5, 6, and 7. If the red LED on the Standby SPE Processor
circuit pack is on and the Standby SPE Processor circuit pack has
been replaced, replace the Standby SPE Memory circuit pack as
described in Chapter 6 and proceed with Steps 5, 6, and 7.
■ If the red LED on the Standby SPE Memory circuit pack is on,
replace the Standby SPE Memory circuit pack as described in
Chapter 6 and proceed with Steps 5, 6, and 7.
■ If neither red LED is on AND if this is the first attempt to clear the
problem, replace the Standby SPE Processor circuit pack as
described in Chapter 6 and proceed with Steps 5, 6, and 7.
■ If neither red LED is on AND if this is the second attempt to clear the
problem (that is, the Standby SPE Processor circuit pack has
already been replaced), replace the Standby SPE Memory circuit
pack as described in Chapter 6 and proceed with Steps 5, 6, and 7.
■ If neither red LED is on AND if this is the third attempt to clear the
problem (the Standby SPE Processor and Standby SPE Memory
circuit packs have been replaced), escalate the problem.
Table 10-388. TEST #318 Shadow Link Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page