User Guide

DEFINITY Enterprise Communications Server Release 5

Maintenance and Test for R5vs/si

555-230-123

Issue 1

April 1997

Maintenance Object Repair Procedures

Page 10-955M/T-ANL (Maintenance/Test Analog Port)

Any FAIL The NPE of the tested port was found to be transmitting

in error. This will cause noisy and unreliable

connections.

1. If the remaining ports are currently not in use (yellow

LED is off), try to reset the circuit pack via the

busyout board PCSS, reset board PCSS, release

board PCSS command sequence. Then repeat the

test.

2. If the test fails again, replace circuit pack.

PASS The port is correctly using its allocated time slots.

User-reported troubles on this port should be

investigated by examining station, trunk, or external

wiring.

Table 10-273. TEST #9 NPE Cross Talk Test — Continued

Error

Code

Test

Result Description/ Recommendation

Continued on next page