User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-924MODEM-PT (Modem Pool Port)
10
Table 10-262. TEST #98 Modem Pool Conversion Resource Loop Around
Test
Error
Code
Test
Result Description/ Recommendation
NONE ABORT Internal System Error.
1. Wait one-minute and try the test again.
2. If the error occurs again, escalate the problem.
5000 ABORT System resources needed to complete the test could not
be allocated for the digital section of the Modem Pool
conversion resource. Ordinarily, this means the
conversion resource or other hardware used during the
test was in use.
1. Wait one minute and attempt the test again.
2. If it is absolutely necessary to test the conversion
resource, the call must be dropped by issuing a
busyout port PCSS command against the
conversion resource. Issue the release port PCSS
command. The busyout and release of the port drop
any existing calls on that port.
3. Run the test again.
4. If the same error occurs while the conversion
resource is idle, busyout and release both Modem
Pool conversion resources on the TN758 Pooled
Modem circuit pack containing the conversion
resource under test. This action drops any existing
calls on that circuit pack.
5. If the test continues to abort, replace the Pooled
Modem circuit pack and retest.
6. If the test continues to abort with this error code after
circuit pack replacement, escalate the problem.
Continued on next page