User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-921MODEM-PT (Modem Pool Port)
10
4000 ABORT System resources needed to complete the test could not
be allocated. Ordinarily, this means the conversion
resource or other hardware used during the test was in
use.
1. Wait one minute and attempt the test again.
2. If it is absolutely necessary to test the conversion
resource, the call must be dropped by issuing a
busyout port PCSS command against the
conversion resource. Issue the release port PCSS
command. The busyout and release of the port drop
any existing calls on that port.
3. Run the test again.
4. If the same error occurs while the conversion
resource is idle, busyout and release both Modem
Pool conversion resources on the TN758 Pooled
Modem circuit pack containing the conversion
resource under the test. This action drops any
existing calls on that circuit pack.
5. If the test continues to abort, replace the Pooled
Modem circuit pack and retest.
6. If the test continues to abort with this error code after
circuit pack replacement, escalate the problem.
65515 ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a
maximum of five times.
2. Issue the test port long command on the port on
which the test aborted. If any test aborted or failed,
follow recommended maintenance strategy for the
appropriate port type (for example, ANL-LINE,
DIG-LINE).
3. If the test continues to abort, escalate the problem.
Table 10-261. TEST #97 Modem Pool Conference Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page