User Guide

DEFINITY Enterprise Communications Server Release 5

Maintenance and Test for R5vs/si

555-230-123

Issue 1

April 1997

Maintenance Object Repair Procedures

Page 10-760HYB-LINE (Hybrid Line)

Table 10-212. TEST #60 Hybrid Line Lamp Updates Test

Error

Code

Test

Result Description/ Recommendation

1 ABORT A request for a remote station lamp update aborted

even though all internal resources were correctly

allocated.

1. Look in the error log for error type 18 (port busied

out) for this port. If this error type is present, release

the port via the release port UUCSSpp command or

the release station extension command, and then

run the test again.

2. Make sure that the terminal is connected.

3. Retry the command at 1-minute intervals for a

maximum of 5 times.

4. If the test continues to abort, escalate the problem.

2 ABORT Internal System Error.

1. Retry the command at one-minute intervals a

maximum of five times.

2. If the test continues to abort, escalate the problem.

3 ABORT The station is in a ready for service or an out of service

state. This may be due to wiring or an unplugged or

defective set.

1. Make sure terminal is connected and the wiring is

correct.

2. Retry the command at 1-minute intervals a maximum

of 5 times.

3. If the test continues to abort, escalate the problem.

Continued on next page