User Guide
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si 
555-230-123 
Issue 1
April 1997
Maintenance Object Repair Procedures 
Page 10-318CO-DS1 (DS1 CO Trunk) 
10
FAIL 1.  Enter the ’list configuration board UUCSS’ 
command. If the circuit pack is a TN767B vintage 8 
or 9, replace the circuit pack with a TN767C V3 or 
later.The error log may have error type 1281 entries.
2. Test all administered trunks on the board. If one 
fails, this could be an off-board problem (such as an 
incoming seizure or an off-hook port seizure during 
the test). Retest the board.
3. If all of the ports fail, check the CARR-POW (see 
Note below).
4. If several ports fail, check the error log for TONE-BD 
or TONE-PT errors. If there are such errors, take the 
appropriate action. When the TONE errors have 
cleared, rerun the test.
5. If the retry passes and troubles have been reported, 
coordinate isolation with the CO. Make sure that the 
switch, the CO, and any NTCE equipment (the 
CSU’s) have the correct administration.
6. Replace the circuit pack.
NOTE:
If the conference circuit test fails for all ports on a 
circuit pack, a -5 volt power problem is indicated. 
If a TN736 or TN752 power unit circuit pack is 
present, either the 631DB AC power unit or the 
676B DC power unit may be defective. (The 
631DB power unit is used in a medium cabinet 
powered by an AC source. The 645B power unit is 
used in a medium cabinet powered by a DC 
power source.) The system may contain a TN736 
or TN752 power unit or a 631DB AC power unit, 
but not both types of power units. To investigate 
problems with a 631DB AC power unit, refer to the 
CARR-POW (carrier port power unit for 
AC-powered systems) Maintenance 
Documentation. To investigate problems with a 
645B DC power unit, refer to the CARR-POW 
(carrier port power unit for DC-powered systems) 
Maintenance Documentation. If a red LED on 
TN736 or TN752 power unit circuit pack is on, 
replace the pack. 
Table 10-89. TEST #7 Conference Circuit Test  — Continued
Error 
Code
Test 
Result Description/ Recommendation
Continued on next page










