User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-104ANN-BD (Announcement Circuit Pack)
10
Clock Match Inquiry Test (#212)
This test is supported to determine the state of the clock generation circuitry on
the Announcement circuit pack. This circuitry is used for controlling various
pieces of the hardware, like the 140AY device. It is also used to synchronize the
Announcement circuit pack with the clock that is on the backplane.
FAIL Test failed. Announcement playbacks should sound corrupted.
1. Reset the circuit pack via the reset board PCSS command and then
run this test again. If the test continues to fail, replace the circuit pack
(see Warning).
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works (see Warning).
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. See "General Notes" near the beginning of this
Maintenance procedure.
PASS The SP can properly process record/playback requests. User-reported
troubles on this circuit pack should be investigated using other circuit pack
and port tests. Refer to "ANN-PT (Announcement Port)" Maintenance
documentation for a description of the port tests.
Table 10-38. TEST #212 Clock Match Inquiry Test
Error
Code
Test
Result Description/ Recommendation
2000 ABORT Response to the test request was not received within the allowable time
period. If Error Type 1538 is present in the Error Log, follow the
maintenance strategy recommended for this Error Type.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Internal System Error.
1. Retry the command at one-minute intervals a maximum of five times.
Continued on next page
Table 10-37. TEST #211 Super Frame Match Inquiry — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page