User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-101ANN-BD (Announcement Circuit Pack)
10
1007 ABORT The Announcement circuit pack thinks that Port 1 or Port 9 is busy.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, follow the Announcement Port
maintenance procedures for Ports 1 and 9.
3. If the Announcement Ports pass all their tests, escalate the problem.
1024 ABORT Announcement circuit pack blocked the test because an announcement
download is in progress. If an announcement download is in progress, a
status data-module <announcement data extension> command should
show that the announcement data port is connected to a NETCON data
channel, and [for G3iV1.1-286] the tape drive should be active or [for
G3sV2, G3iV2-386, or G3vsV2] the "card-in-use" amber LED for the
memory card should be on (to determine the extension of the
announcement data module, use the list data-module command). See
Note (a) at end of table for more information.
1. Wait until download is finished (can take up to 45 minutes), and then
run the test again.
2. If the test continues to abort and there is no download in progress,
escalate the problem.
2000 ABORT Response to the test request was not received within the allowable time
period. If Error Type 1538 is present in the Error Log, follow the
maintenance strategy recommended for this error type.
1. Retry the command at one minute intervals a maximum of 5 times.
2007 ABORT The Announcement circuit pack thinks that Port 1 or Port 9 is busy.
1. Retry the command at one-minute intervals a maximum of five times.
2. If the test continues to abort, follow the Announcement Port
maintenance procedures for Ports 1 and 9.
3. If the Announcement ports pass all their tests, escalate the problem.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
ABORT Internal System Error.
1. Retry the command at one-minute intervals a maximum of five times.
Table 10-36. TEST #210 140AY Loop Around Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page