User Guide

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-96ANN-BD (Announcement Circuit Pack)
10
Announcement Checksum Test (#209)
Associated with every recorded announcement is a checksum. In this test, the
SP checks a stored global checksum covering all recorded announcements
against a calculated one and returns the results to the maintenance system. If the
global checksum failed, maintenance requests the SP to check each individual
announcement’s checksum.
If the test fails, then it returns the total number of defective announcements
found. In addition, associated with each failure is an error in the Error Log (Error
Type 14). The Aux Data indicates the number of the first defective announcement
found. This number corresponds to the announcement numbers on the
announcement form. The extension relating to the announcement can be
determined by the display announcement command.
FAIL Test failed. Circuit pack cannot be used. Announcement speech
memory is cleared when this test fails. Therefore, when the problem
has been resolved, announcements must be rerecorded or
downloaded to the circuit pack. Refer to "General Notes" near the
beginning of this Maintenance documentation.
1. Reset the circuit pack via the reset board PCSS command and then
run this test again. If the test continues to fail, replace the circuit pack
and then run this test again.
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works.
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. See "General Notes" near the beginning of this
Maintenance documentation.
PASS The communications link between the two processors on the
Announcement circuit pack is functioning properly. User-reported troubles
on this circuit pack should be investigated using other circuit pack and
port tests. Refer to "ANN-PT (Announcement Port)" Maintenance
documentation for a description of the port tests.
Table 10-34. TEST #208 Angel-Speech Processor (SP) Handshake Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page