MDW 9030P Wireless Pocketphone Quick Reference 503-801-161 Comcode 107993149 Issue 2 March 1997
MDW 9030P Wireless Pocketphone Quick Reference Handset Controls Headset On/Off Receiver Press to turn the headset on if the headset is plugged in. ON appears in handset display. To turn off, press again. Turn on to make or answer a call, and turn off to “hang up.” Receives the sound of your caller's voice, unless a headset is connected. Antenna Extend fully to maximize the handset range and voice quality. Lanyard Loop Attach lanyard for carrying handset.
Handset Display 3 4 5 6 1 MSG RANGE ON 2 MUTE 9 8 1 2 7 Information you would see on a wired system phone's display, (except time), based on your communications system: LCL:P, D, M1, or M2= Local Mode:communications system WIRELESS TEST=Handset in Wireless Test Mode VIBR=Vibrator enabled PSEL=Line Preselection enabled PRESELECTION:ON / OFF=Line Preselection Mode:status CHANGE BUTTN MAP=Communications system setting is wrong MAP:P, D, M1, M2=Button Mapping Mode: setting NO LINK=Handset is not co
Volume Adjustment To increase or decrease the volume of the handset alerter or the receiver (earpiece): ■ Alerter: Press the "+" or the "–" button while the MDW 9030P is awake but turned off. If the display is dark (the phone is in "sleep" mode), press " to wake it up, then press the "+" or the "–" button. ■ Receiver: Press the "+" or the "–" button while the MDW 9030P is turned on.
Making a Call 1. Press O. 2. If desired, press " to move the Selection rectangle; then press ' corresponding to the line you want. 3. Dial the call. 4. To end the call, press O. Answering a Call 1. Press O. 2. Speak into the handset. 3. To end the call, press O. Preselecting a Line or Button Once Line Preselection is enabled, proceed as follows: 1. If the display is blank, press ". 2. If necessary, press " to move the Selection rectangle. 3. Press ' corresponding to the line or button you want. 4.
