User's Manual

Chapter 5 Cajun Campus CLI (Command Line Interface)
48 Cajun P333T User’s Guide
SNMP config change traps enabled.
Console> (enable)
To enable all traps to a specific manager:
Console> (enable) set snmp trap 192.122.173.42 enable all
All SNMP traps enabled.
Console> (enable)
To disable SNMP config traps to a specific manager:
Console> (enable) set snmp trap 192.122.173.42 disable config
SNMP config traps disabled.
Console> (enable)
To add an entry in the SNMP trap receiver table with default:
Console> (enable) set snmp trap 192.122.173.42
SNMP trap receiver added.
Console> (enable)
Set system location command
Use the Set system location command to set the mib2 system location MIB variable.
The syntax for this command is (a string of 2 words or more must be type inside
inverted commas – e.g. ‘Operations Floor’ ):
set system location
[string]
Set system name command
Use the Set system name command to set mib2 system name MIB variable.
The syntax for this command is:
set system name
[string]
string location string. The location is cleared if this field is blank.
string
location string. The location is cleared if this field is blank.