User's Manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-812ISDN-SGR (ISDN-PRI Signaling Group)
10
Figure 10-55. PRI Over PACON Remote Layer 3 Query (Test #637)
Table 10-225. TEST #637 Remote Layer 3 Query
Error
Code
Test
Result Description/Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1006 ABORT This is a NORMAL ABORT. For country protocol 1 interfaces
(including the USA), either there are no B-channels administered in
this signaling group, or all B-channels in this signaling group are
either out-of-service or are in a "pending" state (PINS or PMTC,
indicating that a B-channel maintenance message for that
B-channel has been sent and not yet acknowledged).
1. Administer an ISDN Trunk or PRI Endpoint Port (B-channel) in
this signaling group, or use the status trunk TRK-GRP/TRK or
status pri-endpoint <extension> command to check the state
of the ISDN Trunks or PRI Endpoint Ports associated with this
signaling group. Refer to ISDN-TRK or PE-BCHL for further
details regarding service state definitions and transitions. For
systems not using country protocol 1 interfaces, there are no
B-channels administered in this signaling group.
1019 ABORT There is already a Remote Layer 3 Query in progress. This is a
normal ABORT.
1. Wait two minutes, then follow the procedures for when this test
passes.
Continued on next page
Packet Bus
To fa r e nd
sw itc h hardw are
Processor
(T N 7 86 )
Packet
Control
Circuit
Pack
(T N 7 78 )
UDS1
In te rfac e
Circuit
Pack
(T N 4 64 *)
*TN464 C or later