User's Manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-435DATA-CHL (Data Channel)
3
1000 ABORT
(cont’d.)
3. Issue the list data-module command to determine if other DATA-CHLs
are administered. If no other DATA-CHLs are administered, administer at
least one at this time.
4. Determine if the DATA-CHLs OTHER THAN the target DATA-CHL are all
in use for some other function (that is, CDR Link, System Printer Link,
Journal Printer Link, PMS Link, or secondary administration terminal
connection) as described previously in the "Status of Data Channels"
section. If so, and if it is necessary to completely test the target
DATA-CHL, use the following preference guidelines to free one of the
DATA-CHLs for testing.
a. If a DATA-CHL is being used for a secondary administration terminal
connection, busyout that DATA-CHL.
b. Otherwise, if a DATA-CHL is being used for a PMS Link, busyout the
PMS Link.
c. Otherwise, if a DATA-CHL is being used for a Journal Printer Link,
busyout the Journal Printer Link.
d. Otherwise, if a DATA-CHL is being used for an CDR Link, busyout the
CDR Link.
e. Otherwise, if a DATA-CHL is being used for a System Printer Link,
busyout the System Printer Link.
5. Retry the command at 1-minute intervals a maximum of 5 times.
6. Restore any busied out CDR, System Printer, Journal Printer, or PMS Link
to service before moving on to another activity.
1006 ABORT For this test, an Error Code of 1006 can have one of several different
meanings:
a. No other DATA-CHLs are administered and, therefore, not available to
place the call to the target DATA-CHL.
b. All other DATA-CHLs are busy and, therefore, not available to place
the call to the target DATA-CHL.
c. System resources required to run this test are not available.
d. Internal system error
Note the results of Tests #110 and #111 in the Short Test Sequence for the
target DATA-CHL. If the results of Tests #110 and #111 are both PASS, then
there is a high probability that the target DATA-CHL is not defective.
Proceed with the remaining steps only if it is necessary to completely test
the target DATA-CHL:
Table 3-187. TEST #109 Data Channel Remote Maintenance Loop Around Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page