User manual

ManualsBrandsLucent Technologies ManualsOtherHome Theater Server 555-233-119

841

842

843

844

845

846

847

848

849

850

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-280BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)

1003 ABORT The system could not allocate a tone receiver for the test. The system may

be oversized for the number of Tone Detectors present or some Tone

Detectors may be out-of-service.

1. Look for TTR-LEV errors in the Error Log. If present, refer to TTR-LEV

(TTR Level) Maintenance documentation.

2. Look for TONE-PT errors in the Error Log. If present, refer to TONE-PT

(Tone Generator) Maintenance documentation.

3. If neither condition exists, retry the test at 1-minute intervals a

maximum of 5 times.

1004 ABORT The port has been seized by a user for a valid call. Use the status station

command for the station associated with this port and determine when the

port is available for testing.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1005 ABORT This test is not valid for this type of translation. Ports administered as

“ASAI” or “ADJK” can not run this test, because the B channels associated

with the port are not used by ASAI or Lucent Adjunct Links. This is a

normal condition.

2000 ABORT Response to the test was not received from the BRI-LINE circuit pack

within the allowable time period.

1. If this result occurs repeatedly, attempt to reset the circuit pack if the

other ports are not in use. Reset the circuit pack by issuing the

busyout board PCSS and the reset board PCSS commands.

2. If this result occurs again, replace the circuit pack.

2012 ABORT Internal system error.

2100 ABORT Could not allocate the necessary resources to run this test.

1. Retry the command at 1-minute intervals a maximum of 5 times.

2103 ABORT The system could not make the conference connection for the test.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1, 2 FAIL As stated previously, this test runs a TDM Loop Around Test on each

B-channel. This indicates that the loop around failed on one of the

channels. Error Code 1 indicates that the TDM Loop Around Test failed on

B1. Error Code 2 indicates that the TDM Loop Around Test failed on B2.

Table 3-120. TEST #619 BRI Port Local TDM Loop Around — Continued

Error

Code

Te s t

Result Description/ Recommendation

Continued on next page