User manual
DEFINITY ECS Release 8.2 Maintenance for R8.2csi 
555-233-119  Issue 1
April 2000
Maintenance Objects 
3-47ANL-24-L (24-Port Analog Line) 
3
Table 3-20. TEST #48 Station Present Test 
Error 
Code
Te st 
Result
Description/Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may 
be busy with a valid call. 
1004 ABORT The port was seized by a valid call during the test. The test has been 
aborted. 
1. Use the display port PCSSpp command to determine the station 
extension. 
2. Use the status station command to determine the service state of the 
port. 
3. If the port is in use, wait until the port is idle and retry the command at 
1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be 
applicable or it may be disruptive to terminal equipment other than a voice 
terminal (for example, the modem pool member or Music On Hold).
1008 ABORT Could not allocate a ringing circuit. Either all the ringing circuits are in use 
or the ringing generator is defective or it is not wired correctly.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Error Log. 
If an ABORT 1008 occurs for this test on other circuit packs as well, 
then the ringing generator may be defective or is not wired correctly 
(see errors for RING-GEN). If it does not occur on other ports, then all 
four ring phases are in use.
1018 ABORT The test has been disabled by administration.The default for the 
Test field 
on the station form is y. Determine why this field has been set to 
n on this 
station (this may be due to the brief ringing disturbance that this test may 
cause).
1. To enable the test for a particular station being tested, enter change 
station extension and set the 
Test? field on the station from n to y.
2000 ABORT Response to the test request was not received within the allowable time 
period.
2100 ABORT Could not allocate necessary system resources to run this test. 
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page










