User manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Commands
2-287status link n
2
Error Counters form (page 2)
Service Port Location Administered port location (assigned by add/change
data-module command)
Service Port Data
Extension
Administered extension number (assigned by add/change
data-module command)
Service State Displays: in-service/idle, in-service/active, disconnected,
out-of-service, maintenance busy, in-service, inactive, active,
idle
Node Name Administered node name (assigned by add/change
data-module command)
Source IP Address Administered IP address (assigned with change node-name or
add/change data-module commands)
Subnet Mask Administered subnet mask address (assigned by add/change
data-module command)
Broadcast Address Administered broadcast address (assigned by add/change
data-module command)
Physical Address The interface’s address (CLAN circuit pack) at the protocol
layer immediately “below” the network layer in the protocol
stack.
Enabled y (yes) or n (no)
Maintenance Busy? y (yes) or n (no)
Active Channels Number of active channels
status link 1 Page 2 of 3
ERROR COUNTERS
Reset Time: 04/08 14:46
Last Hour Start Time: End Time:
Incoming Received: Unicast Pkts Multicast Pkts Octets
Since Reset
Last Hour
Incoming Dropped: Error Pkts Discard Pkts
Since Reset
Last Hour
Outgoing Transmitted: Unicast Pkts Multicast Pkts Octets
Since Reset
Last Hour
Outgoing Dropped: Error Pkts Discard Pkts
Since Reset
Last Hour
CRC Check: 0 Collision Count: 0