User manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Commands
2-86display system-parameters maintenance
2
Modem Connection
On page 3 of the example forms shown below, there are 11 fields that are hidden
when the
Modem Connection?
field is set to
none
. In this example the
Modem
Connection
field is set to
external
, and these additional 11 fields are visible.
The first 2 fields on page 3 help setup the data format for the serial data from the
switch to the modem.There are only two valid combinations for these 2 fields:
■ Data Bits = 8, Parity = None
■ Data Bits = 7, Parity = (odd, even, mark, or space)
The remaining fields are listed below:
No. of Parties to Be
Conferenced Enter Digit
32
43
54
65
76
SPE Optional
Boards:
These fields indicate whether a Disk circuit pack is present in the
system, and which Packet Interface slots are administered. If a
Packet Interface circuit pack is physically present, the
corresponding Packet Interface field is set to y when the system
boots, and no change to that field is allowed. If the system is
equipped with duplicated SPEs, a Packet Interface field is set to
y
when either SPE carrier contains a Packet Interface circuit pack in
the corresponding position. If a Packet Interface circuit pack is not
present, then the value for the Packet Interface field is read from
translation data stored on disk or tape. If the field is set to
n
, a
Packet Interface circuit pack may be administered by changing the
corresponding Packet Interface field to
y
.
Modem Connection
None or external (none)
Modem Name
This field is 20 characters long and will permit alpha-numeric
characters to provide a unique qualifier for a given modem. ( )
RTS/CTS Enabled
This field will inform the modem that communication with the data
source UART will be driven with RTS/CTS flow control. This field is 6
characters long and is case in-sensitive. (&H1)
Asynchronous
Data Mode
This field will configure the modem as an asynchronous
communications device. This field is 8 characters long and is case
in-sensitive. ( )