User manual

ManualsBrandsLucent Technologies ManualsOtherHome Theater Server 555-233-119

1801

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-1247UDS1-BD (UDS1 Interface Circuit Pack)

Table 3-533. TEST #1214 One-Way Span Test

Error

Code

Te s t

Result Description/ Recommendation

ABORT Internal system error

1. Retry the

test ds1-loop UUCSS one-way-span-test-begin

command at

1-minute intervals a maximum of 5 times.

1005 ABORT One-Way Span Test cannot be executed in the current configuration. To run

this, the TN464F or later suffix UDS1 must be administered for 24-channel

operation. The "Bit Rate" field on the DS1 circuit pack administration form must

be set to "1.544" for 24-channel operation.

1015 ABORT Ports on the UDS1 Interface circuit pack have not been busied out to

out-of-service.

1. Enter the busyout board UUCSS command to put all trunks or ports of

the UDS1 Interface circuit pack into the out-of-service state.

2. Retry the command.

1039 ABORT The UDS1 Interface circuit pack is providing timing for the system. Executing

this test could cause major system disruption.

If the UDS1 Interface circuit pack needs to be tested, set the synchronization

reference to another DS1 Interface circuit pack or to the Tone-Clock circuit

pack via the following command sequence:

1. Issue the disable synchronization-switch command.

2. Next, issue the set synchronization UUCSS command.

3. Lastly, issue the enable synchronization-switch command.

1950 ABORT Another loopback/span test is already executing on the DS1 board or the

board is in a network requested loopback mode (Line loopback or Payload

loopback). The hardware error log will indicate whether a Customer Loopback

Jack Test, Far CSU Loopback Test, or the One-Way Span Test is executing or if

the board is in line loopback or payload loopback mode. Only one

long-duration loopback/span test can be active at a given time. Thus, if a

loopback/span test is already active, that test must be terminated via the

test

ds1-loop UUCSS end-loopback/span-test

command in order to execute this

test.

Continued on next page