User manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-1156TSC-ADM (Administered Temporary Signaling Connections)
3
1145 ABORT There is congestion in the network.
1. Issue the status tsc-administered command at 1-minute intervals a
maximum of 5 times.
2. If the congestion does not clear, disable and enable the Administered
TSC via the change sig-group <group> command. To disable the
Administered TSC, display the (administration) Signaling Group Form
via the change sig-group <group> command where <group> refers
to the number of the signaling group under which the suspect TSC is
administered. Change the
Enable field to n. To enable the ADMTSC,
change the
Enable field to y.
3. If the congestion still does not clear, check other nodes in the network.
1146 ABORT The congestion just occurred in the network.
1. Issue the status tsc-administered command at 1-minute intervals a
maximum of 3 times.
2. If congestion does not clear, disable and enable the Administered TSC
via the change sig-group <group> command. To disable the
Administered TSC, display the (administration) Signaling Group Form
via the change sig-group <group> command where <group> refers
to the number of the signaling group under which the suspect TSC is
administered. Change the
Enable field to n. To enable the ADMTSC,
change the
Enable field to y.
3. If congestion still does not clear, check the other nodes in the network.
1147 ABORT The ADMTSC is being torn down.
1. Issue the status tsc-administered command at 1-minute intervals a
maximum of 3 times.
2. If ADMTSC is still down, disable and enable the ADM TSC via the
change sig-group <group> command. NOTE: To disable the
ADMTSC, display the (administration) Signaling Group Form via the
change sig-group <group> command where <group> refers to the
number of the signaling group under which the suspect TSC is
administered. Change the
Enable field to n. To enable the ADMTSC,
change the
Enable field to y.
3. If the ADMTSC is still down, check the other nodes in the network.
1148 ABORT The ADMTSC is enabled, but inactive (near-end).
1. Disable and enable the ADMTSC.
2. Reissue the test tsc-administered command.
3. If the ADMTSC is still inactive, check the other nodes in the network.
Table 3-508. TEST #604 TSC Heartbeat Inquiry Test — Continued
Error
Code
Te s t
Result Description/ Recommendation
Continued on next page