User manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-1148TRANS-ID (Translation-ID)
3
Processor circuit pack replacement
When replacing a processor circuit pack, follow the procedures in Table 3-505:
■ Standard Reliability:
— Begin the procedure with
Step #3 .
■ High and Critical Reliability:
— Follow the procedure through once. Work on the standby side first,
then on the active side.
NOTE:
Translations loaded from a duplicated system flash card into a simplex
system, even where one of the translation IDs on the flash card
corresponds to the ID on the processor, results in translation ID mismatch.
Table 3-505. Processor circuit pack replacement procedure
√ Step Description Command Procedure
1. Supress alarms change
system-parameters
maintenance
Change the Alarm
Origination to OSS
Numbers field to neither
(Screen 3-5
).
Press Enter to effect the
changes.
2. Busyout the standby
PPN
busyout
standby-spe
3. Remove the old
processor circuit pack
Unlatch the old processor
circuit pack and slide it out of
its slot (no power-down
required).
4. Replace the
processor
Slide the replacement
processor circuit pack in the
slot and latch securely.
5. System detects ID
mismatch
The system detects the
translation ID mismatch,
displays the warning message,
and generates a MAJOR alarm
(TRANS-ID).
6. Release standby PPN release standby-spe Releases the standby PPN.
Continued on next page