User manual

ManualsBrandsLucent Technologies ManualsOtherHome Theater Server 555-233-119

1471

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-918PMS-LINK (Property Management System Link)

for five minutes before attempting to set up the link again. If this error type

recurs frequently (that is, more than once a month), advise the customer to

call the vendor of the PMS to check out the PMS device. Once the PMS

Link is successfully established, this error disappears from the Hardware

Error Log (see Note).

NOTE:

The PMS should be checked for adherence to message rate defined

in the PMS/PBX protocol specifications. No alarm is raised against

this error.

i. The attempt to swap the database between PBX and PMS failed 3 times

consecutively due to excessive PMS/PBX protocol violations, buffer

overflows, or PMS Link outages. The PMS Link is NOT torn down. If this

error type recurs frequently (that is, more than once a month), then advise

the customer to call the vendor of the PMS to check out the PMS device.

Once the PMS Link is successfully established, this error disappears from

the Hardware Error Log. No alarm is raised against this error.

j. The PMS Link has been busied out for system technician-demanded

maintenance via the

busyout pms-link

command or has been brought

down via the

test pms-link long

command. The PMS Link is torn down,

and PMS Link maintenance stops attempting to reestablish the link in the

case where the

busyout pms-link

command has been used. When the

test pms-link long

command has been used, PMS Link maintenance

continues to try to reset the link. To restore the PMS Link after use of the

busyout pms-link

command, issue the

release pms-link

command. To

restore the PMS Link after use of the

test pms-link long

command, issue

the

test pms-link

command.

k. The PMS Link is physically established, but the protocol has not been

started by the PMS before the protocol timer expires. The PMS Link is NOT

torn down. If this error type recurs frequently (that is, more than once a

month), advise the customer to call the vendor of the PMS to check out the

PMS device. Once the PMS Link is successfully established, this error

disappears from the Hardware Error Log.

NOTE:

The PMS should be checked to make sure that it attempts to start the

protocol according to the PMS/PBX protocol specifications. No

alarm is raised against this error.