User manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-860OPS-LINE (DS1 OPS Line)

Audit and Update Test (#36)

This test sends port level translation data from switch processor to the DS1

Interface circuit pack to assure that the trunk’s translation is correct. Translation

updates include the following data: trunk type (in/out), dial type, timing

parameters, and signaling bits enabled. The port audit operation verifies the

consistency of the current state of the trunk as kept in the DS1 Interface circuit

pack and in the switch software.

PASS The port can correctly conference multiple connections. User-reported

troubles on this port should be investigated using other port tests and

by examining station, trunk, or external wiring.

0NO

BOARD

The test could not relate the internal ID to the port (no board). This

could be due to incorrect translations, no board is inserted, an incorrect

board is inserted, or an insane board is inserted.

1. Check to ensure that the board translations are correct. Use the list

config command, and resolve any problems that are found.

2. If the board was found to be correctly inserted in step 1, issue the

busyout board command.

3. Issue the reset board command.

4. Issue the release busy board command.

5. Issue the test board long command. This should re-establish the

linkage between the internal ID and the port. If this is not the case,

dispatch to check to ensure that there is a valid board inserted.

Table 3-372. TEST #7 Conference Circuit Test — Continued

Error

Code

Test

Result Description/ Recommendation

Continued on next page