User manual

ManualsBrandsLucent Technologies ManualsOtherHome Theater Server 555-233-119

1411

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-849MMI-PT

Table 3-368. TEST #1111 Resource Looparound Test

Error

Code

Te s t

Result Description/Recommendation

1000 ABORT System resources required to run this test are not available. The port may be

busy with a valid call.

1. Retry the command at 1-minute intervals a maximum of five times.

2. Use the status conference command to determine if there is an active

conference. If a call is active, the test cannot be run until the conference

call terminates.

1002 ABORT The system could not allocate time slots for the test. The traffic load on the

system may be very high or time slots may be out-of-service due to TDM-Bus

errors. Refer to ‘‘TDM-BUS (TDM Bus)’’

to diagnose any active TDM Bus

errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic,

repeat the test at 1-minute intervals a maximum of five times.

1003 ABORT The system could not allocate a tone detector for the test. The system is

oversized for the number of tone detectors present or some tone detectors

are out-of-service.

1. Resolve any ‘‘TTR-LEV (TTR Level)’’

errors in the Error Log.

2. Resolve any ‘‘TONE-PT (Tone Generator)’’

errors in the Error Log.

3. If neither condition exists, retry the test at 1-minute intervals a maximum

of five times.

1004 ABORT The resource has been seized by a user for a valid call. Use the status

conference command to verify that there is a conference call active.

1. If there are no conference calls, retry the command at 1-minute intervals

a maximum of five times.

2000 ABORT Response to the test was not received from the Tone Detector circuit pack

within the allowable time period.

1. If this result occurs repeatedly, reset the circuit pack, if the other ports

are not in use. Reset the circuit pack by issuing the busyout board

PCSSpp and the reset board PCSSpp commands, followed by the

release board PCSS command.

2. If this result occurs again, replace the circuit pack.

2012 ABORT Internal system error

2100 ABORT Could not allocate the necessary resources to run this test. Abnormal abort.

1. Retry the command at 1-minute intervals a maximum of 5 times.

Continued on next page