User manual

ManualsBrandsLucent Technologies ManualsOtherHome Theater Server 555-233-119

1291

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-731ISDN-SGR (ISDN-PRI Signaling Group)

Table 3-308. TEST #647 Layer 2 Status Query Test

Error

Code

Te st

Result Description/ Recommendation

1132 ABORT Internal system error

The port location for the primary ISDN-PRI D-channel is not known. This

condition should not be possible since an administered DS1 circuit pack

must be specified when a Signaling Group is administered:

1. Retry the command at 1-minute intervals a maximum of 5 times.

1134 ABORT Internal system error

The associated DS1 circuit pack is not administered. This condition should

not be possible since an administered DS1 circuit pack must be specified

when a Signaling Group is administered.

1. Retry the command at 1-minute intervals a maximum of 5 times.

2500 ABORT Internal system error

1. Retry the command at 1-minute intervals a maximum of 5 times.

1 FAIL Layer 2 of the primary signaling channel is down:

1. Examine the results of the Primary Signaling Link Hardware Test (#636)

and follow recommendations provided there.

2. If test #636 passes, the Layer 2 Query test may still fail if the Signaling

Channel at the far end has not been administered correctly or if it has

been busied out. Verify that the Primary Signaling Channel (D-channel)

at the far end has been administered correctly. Verify that the DS1 port

used for the Primary D-channel has not been busied out at the far end.

2 FAIL Layer 2 of the secondary signaling channel is down.

1. Examine the results of Secondary Signaling Link Hardware Test (#639)

and follow recommendations provided there.

2. If tests #639 passes, the Layer 2 Query test may still fail if the Signaling

Channel at the far end has not been administered correctly or if the

Signaling Channel has been busied out. Verify that the Secondary

Signaling Channel (D-channel) at the far end has been administered

correctly. Verify that the DS1 port used for the Secondary D-channel

has not been busied out at the far end.

Continued on next page