Switch Release Notes

Configuring the Cajun P550 Switch (Layer 2 & Layer 3)
3
-
22 Cajun P550/P220 Switch Operation Guide
3.
To set Fast Start mode on individual ports, in the
Name
column, click the
port
name
for the selected module. The Switch Port Configuration dialog box opens.
Or
To set Fast Start mode on all ports in a module, click
All Module Switch Port
Configuration
. The Switch Port Configuration on All Ports dialog box opens.
4.
From the
Fast Start
pull-down menu, select
Enable
to enable Fast Start mode on
the selected module ports.
5.
Click
APPLY
to save your changes, or
CANCEL
to clear your selection.
Using the All Ports Configuration Dialog Box
The All Ports Configuration dialog box allows you to apply the same parameter settings
to all switch ports in a module using a single command.
To set all switch ports in a module using a single command:
1.
In the
System Configuration
section of the Web Agent window, select
Modules
& Ports
. The Module Information dialog box opens.
2.
In the
Ports
column, click the
number
of ports listed for the module you want to
configure (for example, 10 for 100Base-FX). The Physical Port Configuration dialog
box opens.
3.
Click
All Module Ports Configuration
at the bottom of the dialog box. The All
Ports Configuration dialog box opens.
4.
Select the port on which you want your changes to occur.
5.
Set port parameters for the selected ports, as described in “Viewing Switch Port
Parameters”, earlier in this chapter.
6.
Click
APPLY
to save your changes, or
CANCEL
to restore previous settings.