Switch Release Notes

Configuring IP Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide 7-17
5.
To enable MTRACE processing, from the
MTRACE
pull-down menu, select
Enable
.
6.
Click
APPLY to save your changes, or CANCEL to restore previous settings.
Modifying IGMP Interfaces
To modify IGMP interfaces:
1. In the IGMP Configuration section of the Web Agent window, click Interfaces.
The IGMP Interfaces dialog box opens.
Note: If no IGMP interfaces are enabled for your existing IP interfaces, you must
first enable a multicast protocol before you can configure IGMP. Refer to
“Creating an IP Interface” earlier in this chapter for more information on
how to select a multicast protocol.
2. Use Table 7-8 to complete your configuration:
Table 7 -8. IGMP Interface Parameters
Parameter Allows you to...
Select Select the interface to be modified.
Interface Display the IP interface that is configured with IGMP.
IP Address Identify an IP address associated with this interface. This
parameter is not configurable from the IGMP configuration
dialog box.
IP Address Mask Identify a subnet mask associated with this interface. This
parameter is not configurable from the IGMP configuration
dialog box.
IGMP Version Specify the IGMP Version (1.0 or 2.0) to associate with the
IGMP interface.
Maximum Groups Specify the number of IGMP Groups that can be active on this
interface. The default value is 32.
Always be Group
Membership Querier
Vers i on 1 .0 : Enable or disable this interface to be the
designated querier.
Vers i on 2 .0 :
• Enable to force this interface to send queries.
• Disable to obey the designated querier election.
Only the designated router will query hosts on your network.
This is disabled by default.
Process Leave Packets Enable to terminate group memberships quickly. (IGMP
Version 2.0 only). The default value is Enabled.
Query Request Interval in
(sec)
Configure the time period between queries. The default value
is 125 seconds.