User manual

I
REMOTE OPERATION
Playing Messages
SCO
1 Dial your telephone number from a touch
tone phone.
2 When the system answers, enter your
Remote Access Code. The system
announces the number of messages
received, then beeps twice.
3 After the two beeps, wait 4 seconds, and
the system plays back messages
— OR —
Press and release Q] to play all messages
— OR —
Press and release 2 to play only new-
messages (if there are no new
messages, the system announces "No
new messages.")
4 To repeat a message — Press and
release \4_ while the message is playing.
To repeat part of a message — Hold
down gj- To resume playing, release H-
To skip a message — Press and release
while the message is playing.
H". To resume playing, release 6.
To stop message playback — Press and
release dl.
To save messages, hang up.
Oeletlng Messages
To delete selected message — Press and
release % while the message is playing.
To delete all messages — After you have
listened to all messages and heard the 2
beeps, press g), [3].
Record Announcement
1 Press [2, [*]•
2 Speak after the beep, then press (U to stop
recording. The system replays your new
announcement.
To review your announcement — Press 0, [7].
Record a Memo
1 Press # and begin speaking after the
beep.
2 Press fs] when you are finished.
Room Monitor with Intercom
You can call the answering system and listen to
any activity in the room.
1 Press :9 , iT to listen for 30 seconds.
2 If you wish, you can press [Tj while
the monitor is active to speak to some-
one in the room (up to 30 seconds).
3 Press iagain during intercom operation
to return to listening only.
4 Press [5j at any time to exit Room
Monitor with Intercom.
Ending the Remote Access Call
Press i¥j, i9]. The system announces "The
machine will now hang up," and disconnects
from the line.
Changing Remote Access Code
1 Press m, [9]. The system announces
"Enter new code."
2 Enter your new Remote Access Code,
^„^y number between 500 and 999. ^_
3 If a valid code is entered, the system
announces the new Remote Access
Code. If an invalid code is entered, the
system beeps 5 times rapidly, then beeps
twice. Repeat Steps 1 and 2.
Turn System Off
Press m, [S.
Turn System On
When the system is off, it answers after 10 rings
and beeps twice.
1 Press 0 to turn the system on.
2 The system beeps twice and is ready to
answer calls and record messages. If the
-t system beeps 5 times, the memory is full.
Memory FuR
If the system answers after 10 rings and beeps
twice instead of playing your announcement, it
might be off or memory might be full.
1 Enter Remote Access Code after 2-beep
signal.
2 Listen to messages, and delete some or
all of them.
3 Press \0] to make sure your system is on
before you hang up.