Wheelchair User Manual

18-16 Preliminary May 9, 2000 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide
Signaling System 7 (SS7)
Configuring an SS7 signaling gateway
Number of CONNECT to ASG: 0
Number of CONNECT_ACK from ASG: 0
Number of SETUP rejected from: L3: 0 CC: 0
Number of DISCONNECT requests from: L2: 0 CC: 0
Number of REGISTRATION to ASG: 0
Number of REGISTRATION_ACK from ASG: 0
Number of DL_REL_IND from L2: 0
Number of DL_EST_IND from L2: 0
Number of T303 expiry events: 0
Number of T305 expiry events: 0
Number of T308 expiry events: 0
Last L3 counters reset timestamp: [02/08/1999 18:47:41]
Data Transport Layer:
Number of link fail-overs: 0
Number of persistent errors: 161
Last error: Persistent Error
Last error status change timestamp: [02/08/1999 18:47:41]
When the command reports no errors, the output contains the following fields:
Output field Description
Initialized successfully
Indicates whether the SS7 layer between the TAOS unit
and the signaling gateway has been successfully
initialized.
Interface state
State of the SS7 interface. A value of Enabled/Up
indicates that the Enabled parameter in the SS7-Gateway
profile is set to yes. A value of Enabled/Down indicates
that the Enabled parameter in the SS7-Gateway profile is
set to yes, but the TCP link to the signaling gateway is
down. A value of Disabled indicates that the Enabled
parameter in the SS7-Gateway profile is set to no.
Diagnostic level
The diagnostic level as specified with the -t option.
Values can be one of the following:
• 0: Disable diagnostic output.
• 1: Show errors only.
• 2: Trace L3 events and states.
• 3: Trace Call Control events.
• 4: Show all task events.
• 5: Dump L3 packets.
• 6: Dump Call Control primitives.
Number of SETUP requests
from:
L2: Number of setup requests from the signaling
gateway (SS7 network) or from incoming calls.
CC: Number of times the TAOS unit tried to make an
outgoing call to the signaling gateway (the SS7
network). Note that outgoing calls are not currently
supported.