DEFINITY® Enterprise Communications Server Release 8, Issue 3.0 (03.0.042.
Copyright 2000, Lucent Technologies All Rights Reserved, Printed in U.S.A. Notice Every effort was made to ensure that the information in this book was complete and accurate at the time of printing. However, information is subject to change. Lucent Technologies Web Page The world wide web home page for Lucent Technologies is: http://www.lucent.
Highlights This change description document describes the changes incorporated in DEFINITY Enterprise Communications Server (ECS), Release 8, Issue 3.0 (03.0.042.2). Highlights of features and enhancements Network Call Redirection Network Call Redirection (NCR) provides the capability to have the public network redirect an incoming call to another destination via Integrated Services Digital Networking (ISDN), without occupying trunks between the DEFINITY and the other location.
Highlights Internet Protocol (IP) Media Processor: TN2302AP The TN2302AP circuit pack is supported by Release 8.3 software and replaces the TN802B Media Processor, with the following proviso. The version of the circuit pack available coincident with Release 8.3 does not support fax. The current release of the circuit pack is intended for configurations requiring IP station and trunk connectivity without fax.
Highlights ARS/AAR Dialing without FAC feature is not generally available in Release 8.3. Although ARS/AAR Dialing without FAC appears on the customer options screen, this feature can only be ordered and activated by using the application process described in the Rapid Response Team website http://info.dr.lucent.com/rapid_ response/. Each customer activating this feature will go through an approval process in which their configuration is analyzed to determine if it is a suitable candidate for the feature.
Highlights 4 Release 8, Issue 3.0 (03.0.042.
Change Descriptions The following problems have been addressed and corrected in DEFINITY Enterprise Communications Server (ECS), Release 8, Issue 3.0 (03.0.042.2). 1. When switching between PPP and X.25 type data modules, two copies of the Establish Connection field on the data module form appeared. 2.
Change Descriptions 8. Automatic Route Selection (ARS) calls were blocked (caller received reorder tone) when trunks were available but in a group controlled by the attendant. Under these conditions, a denial event will be logged when an ARS call fails and at least one of the trunk groups in a preference is controlled by the attendant. 9. It was possible to remove the administration for the TN802B or TN799B circuit packs even if an IP-interface was administered for that board. 10.
Change Descriptions 3) The Maximum allowed IP SoftPhones was controlled via the “Maximum IP SoftPhones” field on the system-parameters customer-options form. have been changed to: 1) It is possible to list all administered IP SoftPhones using the “list multimedia ip-station” command. 2) Access to the “list multimedia ip-stations” command is blocked using the “mm-ip-stations” keyword on the permissions form.
Change Descriptions 30. Tandem trunk calls that received an ALERT followed by a DISCONNECT that had a progress indicator IE did not send a CONNECT message back to the orginator before the DISCONNECT, even though the incoming trunk was administered to do so. 31. Under some conditions, call record exhaustion occurred. 32.
Change Descriptions 43. The administration field used to administer a user-translated version of the display message viewed when you use the button view feature on the DID-view button was located on the display-messages property-management form. The field is now located on the display-messages view-buttons form. Only the first 24 characters of the user-translated button view display message for the DID-view button are retained. The last 16 characters are truncated. 44.
Change Descriptions 55. When Cyclical Redundancy Check (CRC) errors occurred on BRI ports, the ports were taken out of service and never put back into service. 56. It was not possible to change an ISDN trunk group to a non-ISDN trunk group if there were many AAR/ARS patterns used in the system. 57. Some incoming trunk calls to the attendant incorrectly displayed “CALL FROM ...” instead of the trunk group name. 58.
Change Descriptions 70. Calls queued to an attendant via direct dial to an attendant VDN were left in queue and could not be answered. 71. If all preferences of a routing pattern with Look Ahead Routing (LAR) enabled were busy for a data call over an ISDN PRI trunk, DEFINITY returned Cause #58 (Bearer Capability Not Presently Available), and Cause #58 did not trigger LAR. 72.
Change Descriptions 83. The switch reset when an agent exited AUX work mode. 84. Russian incoming toll intrusion on a call over a Russian 3-wire rotary trunk to a far end BUSY subscriber caused the caller’s station to enter a non-functional state, requiring a Busy/Release to return it to service. The Russian incoming toll intrusion attempt is now denied unless the far end subscriber has actually answered the call, and the caller’s station idles correctly when the station goes on-hook. 85.
Index Feature or category See item numbers Feature or category See item numbers A D Adjunct Switch Applications Interface (ASAI) 50 DEFINITY Wireless Business Systems (DWBS) 17, 25, 46 Administration Digital European Cordless Telephone (DECT) 17, 25, 46 1, 3, 6, 9, 19, 41, 43, 54, 56, 58, 72, 80 Administration Without Hardware (AWOH) 21, 52 Analog Stations 2, 74 Answer Detection 26 Attendant 8, 13, 20, 22, 53, 70, 89 Digital Signal Level 1 (DS1) 88 Digital Stations 2, 21, 45 Displays 34,
Index of Changes Feature or category See item numbers Music on Hold 32 P Paging 65 Q QSIG 18 R R2-MFC Signaling 61 Restart 75 Routing 58 Russia 17, 84 S Service Observing 63 Station Message Detail Recording (SMDR) 78 System Resets 11, 27, 41, 47, 79, 81, 83, 85, 86, 87 T Terminal Translation Initialization (TTI) 72 Transfer 11, 38, 63, 68 Trunk Answer Any Station (TAAS) 51 Trunks 5, 12, 20, 56, 69, 76, 85, 93 U Upgrades 14 24 Release 8, Issue 3.0 (03.0.042.
