Instruction Manual

Installation Instructions
2 | P a g e v 1 . 1 ( 02/ 2 0 2 3 )
Installation Directions
1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material.
2. Ensure the power is OFF before install the luminaire. (Fig. 1).
3. Cut an installation hole of Ø80mm into the wall. (Fig. 2).
4. Connect the mains supply wire to a Class II terminal block/box (not included). (Fig. 3)
Mains Supply Wire Luminaire Wire / Wire Label
Neutral – Blue or Black N or Blue (Neutral)
Live – Brown or Red L or Brown (Live)
5. Ensure that the wires are secure and no bare wires are exposed. (Fig. 3)
NOTE: This is a Class II luminaire and must be maintained during wiring and installation.
6. Push the springs back and install the recessed luminaire through the cut-out hole (Fig. 4).
7. Ensure all the clearance values are maintained during and after installation of the luminaire, thermal insulation, loose
fill insulation, loose combustible materials and any structural members.
NOTE: Please refer to the Clearance Information section and the IC-4 section in this instruction manual for
further details.
8. After the installation, switch on the luminaire to test all the lighting functions and enjoy your new luminaire.