Installation Guide

Installation Instructions
3 | P a g e v 1 . 0 p u b l i s h e d o n 0 6 2 0 1 7
Installation directions
1. Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
2. Remove the mounting bracket from the body of the fitting by loosening the screw using an allen key.
3. Use the mounting bracket as a template to mark the screw positions onto the wall.
Drill holes into the wall and push the plastic anchors into the holes.
4. Loosen the cord anchorage near the terminal block.
5. Push the mains supply wire through the cord entry point on the mounting bracket. Depending on the installation
location, additional silicon may need to be added to maintain the IP44 rating of the fitting.
6. Connect the mains supply wire to the terminal block provided. Ensure that the wires are secure and no bare
wires are exposed.
Mains Supply Wire Wiring Label
Earth – Yellow/Green Yellow/Green
Neutral – Blue or Black N (Neutral)
Live – Brown or Red L (Live)
7. Install the mounting bracket onto the wall by using appropriately sized mounting screws, plastic washers and
anchors.
8. Ensure the screws, plastic washers and anchors used are suitable for the mounting surface.
9. Place the mains supply wire in the cord anchorage system and secure by tightening the screws again.
10. Install the fitting back onto the mounting bracket.
11. Tighten the two screws using an allen key.
Adjust the LED heads and PIR sensor to the desired position.
12. Switch the power to circuit back ON only after all electrical work has been fully completed and the fitting is fully
assembled and is ready to use for the first time.