Installation Guide

Installation Instructions
2 | P a g e v 1 . 0 (06 / 2 0 2 2 )
NOTE: Testing cannot account for installation variables such as variation in mains supply voltage, cable capacitance,
electrical noise, transients, surges and ripple control signals (commonly found in NSW & QLD).
NOTE: The information provided is correct to the best of Beacon Lighting’s knowledge at the date of publication.
• This recessed luminaire has an insulating ceiling type IC-4 rating. Building insulation material can safely be exposed
continuously to temperatures up to 90°C may abut and cover the luminaire. (Please refer to the Clearance
Information section and the IC-4 rating section in this instruction manual for further details.)
• If loose fill insulation or thermal insulation is not fixed into position or if there are loose combustible materials (e.g.
leaves or combustible materials stored in the roof space), a barrier or guard is required as per the Clearance
Information section in this instruction manual.
• The LED driver must be placed at least 100mm away from the LED downlight module to allow for cooling.
• The LED driver can be placed under the insulation. (Please refer to the Clearance Information section in this
instruction manual for further details.)
• The LED downlight module is only suitable for use with Lucci LED Driver
model#: LB-PD-2621-11.5W.
• The recessed luminaire must not be used if the diffuser has been cracked or damaged.
• Take care not to pull any electrical wires during unpacking as this may damage the connection.
• Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
• Check whether the recessed luminaire has been damaged during transport. Do not operate/install any product
which appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or
replacement.
• Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.